Skip to the content
Prescott ValleyPlumber

Garbage Disposal Repair in Prescott Valley, AZ

The motor hums, the blades sit still or water drips under the sink. Power off, then try a hex key and a reset.

Garbage disposal repair with a hex key at the base of the unit

Power off before anything else

Never put a hand into a disposal, even when it is switched off.

Switch the disposal off at the wall and unplug it under the sink, or turn off its breaker. Use tongs or pliers to lift anything out of the chamber, and keep a flashlight handy to see inside.

Sink drain pipes and fittings below a kitchen sink

Two checks that fix many disposals

Both take a few minutes and no special tools

  1. Free the jam from below

    Most disposals have a small hex socket in the center of the bottom. With the power off, fit the hex key that came with it, or a standard one, and work it back and forth until it turns freely.

  2. Press the reset button

    A small red or black button on the bottom trips when the motor overheats. Wait a few minutes for it to cool, then press it firmly and try the switch again.

If the disposal hums but still will not turn after both, or it trips the reset again straight away, the motor or the bearings may be failing. That is the point to call.

Garbage disposal repair, symptom by symptom

Garbage disposal repair in Prescott Valley usually starts with what you hear or see. Each symptom points to a different fault.

What happensUsual causeNext step
Hums but does not spinSomething jammed between the plate and the ringTurn the hex socket underneath
Nothing at allReset tripped, breaker off or a wiring faultPress reset, check the breaker
Grinding or rattlingA spoon, bottle cap or bone in the chamberPower off, remove it with tongs
Leaks from the topLoose sink flange or worn putty sealCall to reseal the flange
Leaks from the sideLoose drain or dishwasher hose connectionTighten gently, or call
Leaks from the bottomCracked housing or failed internal sealUsually a replacement
Drains slowlyFood packed in the drain line beyond the disposalRun cold water, do not add chemicals

What a disposal should never see

Most disposal problems start with something that should have gone in the trash.

  • Grease and oil

    It coats the blades and the drain line, then sets hard.

  • Fibrous peels

    Celery, corn husks and onion skins wrap around the plate.

  • Starchy food

    Potato peels, rice and pasta swell into a paste.

  • Coffee grounds

    They settle in the drain line like sand.

  • Eggshells

    The thin membrane wraps the parts and the shell adds grit.

  • Bones and pits

    Hard items can jam the plate or crack the housing.

Clogged drains around the holidays are a common reason for calls in Prescott Valley, and the disposal is often where it starts. Scrape big meals into the trash and run the disposal in short bursts.

Leaks under the sink, traced

A leak under the kitchen sink can come from several places, and the disposal is only one of them. Dry everything with a towel, run water and watch where the first drop appears.

  • At the sink flange where the disposal meets the sink.
  • At the dishwasher hose connection on the side.
  • At the drain pipe connection leading to the trap.
  • From the bottom of the disposal housing.
  • From the faucet supply lines, which are easy to mistake for the disposal.

If the water is coming from the supply lines or the faucet, see faucet and sink repair instead.

Under sink plumbing with a drain trap and supply lines

Repair the disposal or replace it

Repair often works for

  • Jams and tripped resets.
  • Loose connections and flange leaks.
  • A disposal that is fairly new.

Replacement is likely for

  • A leak from the bottom of the housing.
  • A motor that hums and will not turn after freeing.
  • An older unit that keeps jamming.

You hear whether the unit can be saved or is due for replacement, and the work goes ahead only if you want it to.

The dishwasher connection

In many kitchens the dishwasher drains through the disposal. A hose runs from the dishwasher to a small inlet on the side of the disposal, so whatever is happening in the disposal affects the dishwasher too.

  • Dishwasher will not drain

    The disposal or the line past it may be clogged. Run the disposal with cold water first.

  • New disposal, no draining

    A knockout plug inside the dishwasher inlet may not have been removed during installation.

  • Water in the sink from the dishwasher

    The shared drain line is partly blocked.

Habits that keep it grinding

  • Run cold water before, during and for a few seconds after using it.
  • Feed food in slowly rather than all at once.
  • Run it every few days so the parts do not rust or seize.
  • Freshen it by grinding a few ice cubes now and then.
  • Keep the switch out of reach of small children.

Garbage disposal questions

Why does my disposal hum but not turn?

Something is jammed between the spinning plate and the grinding ring. With the power off, turn the hex socket on the bottom to free it.

Where is the reset button?

On the bottom of the disposal, usually a small red or black button. Let the motor cool for a few minutes before pressing it.

Is it safe to use chemical drain cleaner in a disposal?

No. It can damage the seals and the housing, and it is dangerous to work on afterwards.

Why does my disposal smell?

Food stuck under the splash guard or in the chamber. Grinding ice and a little dish soap with cold water usually helps.

Can a disposal leak cause damage?

Yes. A slow leak can soak the cabinet floor and grow mold, so dry it and have it fixed.

How long does a disposal last?

It depends on use and care. Repeated jams, leaks from the housing and loud grinding are signs it is near the end.

Why does my dishwasher drain into the disposal?

Many dishwashers drain through the disposal. If the disposal is clogged, the dishwasher may not drain properly either.

Can a disposal be added to a sink that does not have one?

Usually yes, if there is power under the sink or it can be added. A plumber checks the drain layout and the space in the cabinet first.

Is it normal for a disposal to vibrate?

A little, while grinding. Heavy shaking or a loud metal noise means something is loose or stuck inside, so switch it off and check.

What if the disposal trips the breaker?

Switch it off and leave the breaker off. A disposal that trips the breaker repeatedly may have a motor or wiring fault that needs checking.

Other kitchen plumbing help

We take garbage disposal repair calls from homes across Prescott Valley, in the 86314 and 86315 ZIP codes.